1. Getting Started with FP/GP-M DLL

Owned by Adam Czajkowski
Last updated: Feb 10, 2023
9 min read

 

 

Figure 1.8: Illustration of how the Multi API-DLL controls the API-DLL instances for FlashPro-M. Calls to the Multi API-DLL are forwarded based on the FPA index.

 

Figure 1.9: Illustration of how the Multi API-DLL controls the API-DLL instances for the GangPro-M. Calls to the Multi API-DLL are forwarded based on the FPA index. Each FPA can program up to 6 targets with a shared Code Data Buffer, or with six(6) distinct Gang Write Buffers to write different data per target. The GangPro-M API-DLL also contains six(6) distinct Gang Read Buffers to read each target individually.

 

 

 

When the FPA index is 0 (ALL-FPAs) then almost all functions are executed simultaneously. Less critical functions are executed sequentially from FPA-1 up to FPA-64 but this distinction cannot be seen from the application software. The longest running programming functions, i.e. F_AutoProgram, are all executed fully in parallel. When different configurations are used for each FPA (i.e. if FPA-1 programs 10kB of data and FPA-2 programs 20kB of data) then the Multi API-DLL function call will return when all API-DLL function calls have finished.

When an inactive FPA index is selected (FPA not initialized), then the return value from selected function is FPA_INVALID_NO (-2 or 0xFFFFFFFE). When all FPA has been selected (FPA index == 0) then only active FPAs will be called. For example if only one FPA is active and FPA index == 0, then only one FPA will be used.

All API-DLL instances used by the Multi API-DLL are fully independent with respect to each other. Data transferred to one FPA does not have to be the same as the data transferred to other FPAs. For example, code data programmed using FPA-1 will use the buffers from API-DLL 1, and code data programmed using FPA-2 will use buffers from API-DLL 2. Once the different code buffers are setup, programming can be done simultaneously using FPA index 0 and the function F_AutoProgram. To configure the data buffers shown in Figure 1.8 use

The major features supported by the API-DLL are:

  • Initialize and terminate communication with FPA and target device,

  • Configure settings from file or using functions,

  • Program code data from file or modify code buffer using functions,

  • Return string report message generated for most actions,

  • Reset target device,

  • Program target device ( erase, blank check, program, verify, lock, and unlock ),

    • Erase all or selected part of memory,

    • Blank check all or selected part of memory,

    • Write code file contents,

    • Verify code file contents,

    • Read all or selected part of memory,

    • Lock memory protection bits and debug access (if supported on device),

    • Unlock device to return memory to factory settings (if supported on device).