Any application using the library will call most of the following functions. First, any one adapter is found, and initialized. Assuming at least one adapter was found (F_OpenInstancesAndFPAs returns > 0), the config and code files are loaded to select the MCU and data to be programmed. Finally, the procedure F_AutoProgram will run the full programming sequence of Erase, Blank Check, Write, Verify, and optionally Lock the MCU.
//Open adapters - this binds adapter(s) to this application. Any adapters not opened here could potentially be opened by another application in parallel.
F_OpenInstancesAndFPAs("*# *");//find any adapter, opens only one
//F_OpenInstancesAndFPAs("*# FPA-1 20171645 FPA-2 20210120 ");//open two adapters over USB
//F_OpenInstancesAndFPAs("*# FPAETH-IP-1 192.168.0.101 FPAETH-IP-2 192.168.0.102);//open two adapters over LAN (XStreamPro-Iso only)
//F_OpenInstancesAndFPAs( <path to FPAs-setup.ini file> );//read configuration from file
//Select adapter index for accepting commands
F_Set_FPA_index (0); //select all opened adapters for sending commands
//F_Set_FPA_index (1); //select only adapter 1 for sending commands
//F_Set_FPA_index (2); //select only adapter 2 for sending commands
F_Initialization(); //initialize selected adapter(s)
F_ConfigFileLoad( <path to config file> ); //config file can be easily created in the GUI, or parameters can be set using F_Set_Config_Value_By_Name
//If the configuration file above already has a valid code path, the following function(s) is(are) not necessary
F_ReadCodeFile( <path to code file> ); //flush code buffer, read first code file. Can be used for *.hex, *.txt, *.srec, *.sxx etc.
//F_ReadCodeFile_BaseAddr( <path to code file>, UINT32 baseAddr ) //same as above but designed for *.bin files. Function will add baseAddr to code address. Can also be used to shift regular code files.
//F_AppendCodeFile( <path to code file> ); //append code file, does not flush code buffer.
//F_AppendCodeFile_BaseAddr( <path to code file>, UINT32 baseAddr ) //same as F_ReadCodeFile_BaseAddr but used for appending
//Factory erase target (optional)
//F_Clear_Locked_Device();
//Erase, Blank Check, Write and Verify code programmed to target(s)
F_AutoProgram();
//Print output
cout << F_Report_Message() << endl;
Running the aforementioned code snippet within the FP-ARM-Demo-C#.exe produces the following result:
Running the aforementioned code snippet within the GP-ARM-PB-Demo-C++.exe produces the following result:
