Introduction to lifecycle management on STM32H563/573 product lines using FlashPro-ARM programmer.

FlashPro-ARM programmer has full support for Debug authentication on STM32H563/573 product lines when TrustZone^© is disabled. TrustZone^© will be added soon.
All STM32H563/573 MCU product states are supported, including provisioning with password management and full regression.

Preparing necessary files

To perform provisioning with password management , the *.obk file needs to be generated by STM32 Trusted Package Creator tool. This file is used to configure the conditions required to preform regression of MCU. Without the password file, full regression is not possible.

Example file is provided in the STM32CubeFW_H5 example provided by ST. The Trusted Package Creator will be used to set up this file using the DA_ConfigWithPassword.xml as input located in/Projects/NUCLEO-H563ZI/ROT_Provisioning/DA/Config path.

To generate a customized configuration file, proceed as follows:

Open Trusted Package Creator and select H5
Open Obkey tab
Select the DA_ConfigWithPassword.xml file
Update the password if needed

Supported operations by FlashPro-ARM

1. Lifecycle and provisioning with password management using FlashPro-ARM

Open FlashPro-ARM
Select STM32H563/573 MCU

Open Setup->Memory Protection dialog
Go to Lifecycle management tab
- Check “Set product state enable” checkbox
- Set finale product state

Use “DA/PROV” button (this step is optional, however without password management, full regression is not possible after moving to a higher lifecycle state)
- Check “Enable provisioning” box
- Use “Browse” button to set path to *.obk file, generated by Trusted Package Creator
- Press “Ok” button in STM32 Debug authentication tab

Press “Ok” button in Memory Protection tab
Check Memory Protection Enable box in the Main GUI

Afterwards use “AUTO PROG” or “Lock Device” buttons in the FlashPro-ARM programmer to put MCU to selected state and perform password management operation.

2. Full Regression

To perform full regression, a *.bin file is needed with a stored password to generate an *.obk file in STM32 the Trusted Package Creator tool (The Trusted Package Creator was needed to perform provisioning with the password management operation).
Example of password.bin file is provided in the STM32CubeFW_H5 example. File located in/Projects/NUCLEO-H563ZI/ROT_Provisioning/DA/Config path.

To perform full regression:

Open FlashPro-ARM
Select STM32H563/573 MCU
Open Setup->Memory Protection tab
Go to lifecycle management tab
Use “DA/PROV” button
- Check “Enable password” box
- Use “Browse” button to set path to *.bin file, with password used to generate *.obk file
- Press “Ok” button in STM32 Debug authentication tab

Press “Ok” button in Memory Protection tab
Press “Clear Locked Device” button

After operation completes, the MCU is back to “Open” state.

3. Discover operation

Discover operation allows the user to read current MCU state and provisioning status.

To perform the discover operation:

Open FlashPro-ARM
Select STM32H563/573 MCU
Open Setup->Memory Protection tab
Go to lifecycle management tab
Use “Discover” button
- In window “Debug Authentication” use “Discover” button to read information from MCU
  - Device ID- id connected MCU
  - Life Cycle - current MCU state
  - Integrity status - provisiong status(0xeaeaeaea mean well provisioned, 0xf5f5f5f5 when provisiong fail, in Open state 0xf5f5f5f5 is normal value)